Kit to build an N Gauge A5 turnout with code 40 Bullhead Rail.

The crossing frog comes as a pre-made casting that simply locates into holes on the base - all the hard work is done for you!

Important Information:

PLEASE NOTE: Other items are required to complete! You will need:

• A 25w Soldering Iron with 2mm Chisel Tip

• Switch Blade Filing & Soldering Jig - A Planing

• 1mm Rosin Core Lead Free Solder

• Sharp File for filing switch blades and cleaning up rail ends

• Butanone Solvent for fixing Chairs to Base

• Xuron type Track Cutters

NOTE: This is a kit that must be assembled and NOT a finished 'ready to lay' turnout. Other components are needed to complete (see above).

A Switch Blade Filing & Soldering Jig (link above) is needed to filing the switch blades and solder the switch blade to the chair plate.

Only recently released models with finer wheels and flanges (models released in the last 10 years) will run on this fine code 40 track system. It is designed to accept stock with a back to back of 7.4mm.

Older rolling stock may need wheels replacing with newer, finer equivalents.

• Download PDF Printable Template (please print at 100% 'no scaling').
  
• Download PDF Wiring Diagram.
  Download PDF Assembly Instructions

• 1x A5 Turnout Base (with pre drilled chair locating holes)
• 1x 1in5 Cast Frog
• Code 40 Bullhead Rail for Stock & Check Rails
• 12x Sprues of Chairs (each sprue holds 2x Slide Chairs, 8x Normal Chairs & 1x Check Rail Chair)
• 1x Tie Bar with Pre drilled holes •